Stainless Mounting Set Spinner

Does a mounting magnet not work on your hubs? Then this is the perfect solution!

The set consists of:
• 1 flat mounting plate with threaded rod and lock nut
• 1 bag of 2-component epoxy glue
• Mixing stick

The mounting plate with threaded rod is glued onto the hub using flat mounting.
The bonding takes place using a special 2-component epoxy adhesive.
On the threaded rod there is a lock nut that ensures the spinner cannot be tightened too far, preventing damage.

Installation manual

• 1 - For maximum strength, it is recommended to lightly sand the surfaces
• 2 - Clean the surfaces thoroughly and make them grease-free
• 3 - Mix the two components (resin and hardener 1:1) very well using the supplied mixing stick
• 4 - Apply the glue evenly on both surfaces
• 5 - Within 2 minutes, place the spinner in the center of the hub
• 6 - Make sure the spinner or hub does not move during curing
• 7 - Let the glue cure for at least 1 hour

Important

Use at your own risk!
Truckjunkie is not responsible for incorrect or improper installation and any resulting damage.

Note

Spinners are not included

✅ Wide range of products
⭐ High-quality products
🚚 Fast delivery
↩️ Easy returns
💬 Friendly customer service for all your questions

Use the FAQ to find the most frequently asked questions about this product.

Still can’t find what you’re looking for? Use the chat box at the bottom right to ask a question or send us an email.